Assess & quote
Site visit, plan review and Dial Before You Dig. One clear quote covering dig, cartage and cleanup.
Kings Cross is a dense art-deco apartment ridge on sandstone, lift-pit and basement work cut into rock on tight lots. The regular jobs here are basement digs, shoring and underpinning. Services located first, sites left level and clean.
Get a free quoteNo obligation, free site quote.
Got it, thanks. We'll be in touch to arrange your site assessment and clear quote.
From a knock-down rebuild to a new estate pad, each service has its own page with the detail.
Kings Cross sits about 3 kilometres east of the city. You'll recognise it by Kings Cross, El Alamein Fountain, the Coca-Cola sign and Victoria Street. It's ringed by Potts Point, Darlinghurst, Elizabeth Bay, Rushcutters Bay and Woolloomooloo. What's changing: basement garages and lift pits cut into rock beneath apartments, and heritage refurbishments.
Most blocks in Kings Cross, around Kings Cross, are art-deco and Victorian apartments and terraces, with dense heritage character. Near Kings Cross, duplex and unit sites cluster near the centres. On a Kings Cross block that usually means basement digs, shoring and underpinning.
Out toward Kings Cross, Kings Cross sits on Hawkesbury sandstone with rock close to the surface on the harbour ridge. Sandstone sits close to the surface around El Alamein Fountain, so a Kings Cross cut is sawn at the boundaries and broken out for anything deep. Around Darlinghurst, the sandstone is sawn at the boundaries and carted out as rock.
Kings Cross is in City of Sydney, and the Kings Cross blocks carry heritage controls, dug to the approved plans. Machines come in to Kings Cross off Victoria Street or Darlinghurst Road, and the fall has to be benched and retained.
Every job follows the same sequence, whether it's a single trench or a full site cut.
A trench can be a day, a basement can be weeks. Dates come with the quote, not after.
Kings Cross and the streets around it, from the older estates to the new blocks.
From the older streets to the newer blocks, Kings Cross and the suburbs around it. If you're anywhere in the Kings Cross area, we can get to you.
See the whole city and South Sydney area →It depends on the volume of material, the ground (hawkesbury sandstone with rock close to the surface on the harbour ridge), access for the machine and how far spoil has to be carted. Every job gets a written quote after a site look, with the dig, cartage and cleanup spelled out, so you know what’s included before anything starts.
Usually, if the excavation is part of a build. Cut and fill beyond set limits, work near boundaries and anything on a lot with a flood, bushfire or heritage overlay needs approval as part of the DA or CDC. We work to the approved plans; check with your certifier before the dig is booked.
A trench, pool dig or single pad is a day or two; a knock-down site cut or a basement runs longer and depends on volume, ground and weather. Dates come with the quote, not after.
Yes. Hawkesbury sandstone with rock close to the surface on the harbour ridge. The inner city sits on sandstone, usually right under the terrace floors. It’s sawn against the party walls and broken out in stages, and it’s in the quote from the site look.
Yes. The party walls are supported to the engineer’s underpinning design, the ground is dug in stages through the front or the lane, rock is sawn at the walls so the neighbours’ footings stay put, and spoil goes out by conveyor. Heritage conditions apply on most of these streets.
Yes. South Sydney basements are shored digs through fill and sand with the water table close, dewatered to the council’s controls, spoil classified and carted to the right facility, and trucks scheduled around the traffic so the street stays open.
Through the front room on boards with the floor protected, or over the roof by crane. Spoil comes out the same way in bins. Slower than anywhere with a side gate and priced for it, but it’s how inner-city courtyards get dug.
Yes. A sloping block is benched into levels with retaining planned in, and the machine is chosen for the grade and the ground. On sandstone slopes the benches are cut into rock. The site look decides the approach.
Tell us about the job. We'll look at the site before quoting, so you know what's included before anything starts.
Request received. We'll be in touch to arrange your site assessment and clear quote.