Assess & quote
Site visit, plan review and Dial Before You Dig. One clear quote covering dig, cartage and cleanup.
Rodd Point is a small waterfront cottage pocket on sandstone at Iron Cove, pool and retaining work on the slope. The regular jobs here are basement digs, pool digs and retaining walls. Services located first, sites left level and clean.
Get a free quoteNo obligation, free site quote.
Got it, thanks. We'll be in touch to arrange your site assessment and clear quote.
From a knock-down rebuild to a new estate pad, each service has its own page with the detail.
Rodd Point sits about 7 kilometres west of the city. Locals place it by Rodd Point, Iron Cove and Bay Run. It's ringed by Russell Lea, Drummoyne, Five Dock and Haberfield. What's changing: basement digs and pools cut into rock, and underpinning and retaining on the steep terrace blocks.
Most blocks in Rodd Point, around Rodd Point, are victorian and Federation terraces and workers cottages, with heritage conservation areas. Near Rodd Point, the older brick and fibro is renovate-or-rebuild ground. Day to day around Russell Lea that's basement digs, pool digs and retaining walls.
On harbour slopes, Rodd Point sits on Hawkesbury sandstone with rock close to the surface, out by Rodd Point. The rock under Iron Cove is close, so Rodd Point footings and pits are broken out and the spoil leaves the block as rock. Around Drummoyne, the sandstone is sawn at the boundaries and carted out as rock.
Rodd Point falls under City of Canada Bay, with heritage and tree protection controls checked at Rodd Point before the plans are followed. Machines reach the Rodd Point block off Henley Marine Drive or Rodd Point, and the slope is worked in benches with retaining, out toward Russell Lea.
Every job follows the same sequence, whether it's a single trench or a full site cut.
A trench can be a day, a basement can be weeks. Dates come with the quote, not after.
Rodd Point and the streets around it, from the older estates to the new blocks.
From the older streets to the newer blocks, Rodd Point and the suburbs around it. If you're anywhere in the Rodd Point area, we can get to you.
See the whole Inner West →It depends on the volume of material, the ground (hawkesbury sandstone with rock close to the surface on harbour slopes), access for the machine and how far spoil has to be carted. Every job gets a written quote after a site look, with the dig, cartage and cleanup spelled out, so you know what’s included before anything starts.
Usually, if the excavation is part of a build. Cut and fill beyond set limits, work near boundaries and anything on a lot with a flood, bushfire or heritage overlay needs approval as part of the DA or CDC. We work to the approved plans; check with your certifier before the dig is booked.
A trench, pool dig or single pad is a day or two; a knock-down site cut or a basement runs longer and depends on volume, ground and weather. Dates come with the quote, not after.
Yes. Hawkesbury sandstone with rock close to the surface on harbour slopes. The ridge suburbs sit on sandstone at or near the surface, often right under the floorboards of a terrace. It’s sawn against the party walls and broken out, and it’s in the quote from the site look.
Yes, and it’s one of the most common Inner West jobs. The house is supported to the engineer’s underpinning design, the ground under it is dug in stages through the front or rear, and rock is sawn at the party walls so the neighbours’ footings stay put. Spoil goes out by conveyor.
Through the house on boards with the floor protected, or over the back fence by crane. Spoil comes out the same way or by conveyor into a skip in the lane. Slower than a side gate and priced for it, but it’s how most Inner West yards get dug.
Conditions on the approval, usually about keeping the front of the house, protecting the neighbours’ walls, and sometimes an archaeologist watching the dig on the oldest streets. Haberfield and the older parts of Balmain, Glebe and Marrickville are the strictest. We dig to what’s approved.
Yes. The old house down, slab and footings out, the block stripped and the new pad cut and compacted, as one run if you want the demolition handled too.
Tell us about the job. We'll look at the site before quoting, so you know what's included before anything starts.
Request received. We'll be in touch to arrange your site assessment and clear quote.